The Nylock nut is an economic locking nut and ideal in applications where vibration or motion could loosen or undo the nut. The nut can also be used to assist sealing the bolt thread against seepage of oil, water, petrol, paraffin and other liquids.
Manufacturing Process : Cold Forge Available in Metric Thread. Available in DIN Standard
A square nut is a four-sided nut. Compared to standard hex nuts, square nuts have a greater surface in contact with the part being fastened, and therefore provide greater resistance to loosening (though also greater resistance to tightening)[citation needed]. They are also much less likely to become rounded-off after repeated loosening/tightening cycles. Square nuts are typically mated with square-headed bolts. Square nuts are used along with flat washers in order to avoid damage from its sharp edges and helps to increase the strength of the fastener.
Manufacturing Process : Cold Forge Available in Metric Thread. Available in DIN Standard
A weld nut is a type of nut that is specially designed to be welded to another workpiece. Different types of weld nuts are used for different purposes. These include round base nuts, slab base nuts, tab base nuts, hex and square nuts, retainer weld nuts, tube end nuts, twin piloted nuts and more.
Manufacturing Process : Cold Forge Available in Metric Thread. Available in DIN Standard
Eye nuts (eyenuts) are fasteners with a looped head. They are designed to receive a hook or rope. Eye nuts are rated for different types of applications and are oval or round in shape. Load-rated eye nuts are designed for vertical lifting, but are not recommended for use with angular lifts. Eye nuts that are not load-rated are designed for use with tie downs and guiding wires.
Manufacturing Process : Hot Forge Available in Metric Thread. Available in DIN Standard
A jam nut is a low profile type of nut, typically half as tall as a standard nut. It is commonly used as a type of locknut, where it is "jammed" up against a standard nut to lock the two in place. It is also used in situations where a standard nut would not fit. The term "jam nut" can also refer to any nut that is used in the same function (even a standard nut used for the jamming purpose). Jam nuts, other types of locknuts, lock washers, and thread-locking fluid are ways to prevent vibration from loosening a bolted joint.
Manufacturing Process : Cold Forge & Hot Forge Available in Metric , BSW, UNC Thread. Available in DIN,BS,ANSI Standard
A flange nut is a nut that has a wide flange at one end that acts as an integrated washer. This serves to distribute the pressure of the nut over the part being secured, reducing the chance of damage to the part and making it less likely to loosen as a result of an uneven fastening surface.
Manufacturing Process : Cold Forge Available in Metric Thread. Available in DIN Standard
Dome nuts cover the threaded end of a fastener meaning that they are especially suitable for when a nut is used in applications where the aesthetics matter. The domed head also acts as a shield from any ends on fasteners that could potentially be dangerous such as sharp bolt threads
Manufacturing Process : Cold Forge Available in Metric Thread. Available in DIN Standard
A wingnut, wing nut or butterfly nut is a type of nut with two large metal "wings", one on each side, so it can be easily tightened and loosened by hand without tools.
Manufacturing Process : Cold Forge & Hot Forge
Available in Metric Thread. Available in DIN Standard
